4/8/2024 0 Comments 6.7 cummins injector removalYou can use a nut of M14 x 1.5 thread and a screwdriver to pull the connector tubes in the head. These tools are discussed below in more detail. At the bottom are a length of 5/16” pushrod with the open end partially squashed to retain a Q-Tip, and a modified rifle bore brush and rod for cleaning out the injector tip hole in the head. ![]() To the left is a “lady foot” pry bar to remove the injectors. Over it and the aluminum plate is a 9” length of 3/16” brake line tubing and 1/4” OD vinyl hose for sucking diesel fuel from the piston bowl if some drains in a cylinder after removing an injector. Next is a blue painted cover for the air intake hole after removal of the air horn. To the right of the nut is an orange painted tube that facilitates pressing the new injector into its well in the head. Under it at the left is a 15/16” socket cut down to 1” total length, with a connector tube nut in it. The aluminum plate at the top keeps the exhaust rockers in order and assembled. ![]() You will need a few specialty tools to make the injector replacement easier. Fuel Injectors for 2003 and Newer HPCR Engines Injector Removal and Replacement
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |